Hydrofoils & Oil Reviews

"If your motor does not have tilt and trim, this product is a good choice to add it to your boat. I had a johnson 115 on mine and it worked flawlessly every time I took my boat out."...(read full reviews)

"I recently purchased this jack plate and I think it was the best set up and all around price.Easy to mount and operate,and you can adjust it on the water unlike some others.Its fairly light but also"...(read full reviews)

"This is a great little product I use for winterizing, just hook the hose up, put it on the outdrive and your good to go. It's also great when you pull your boat out of storage to run some clean water"...(read full reviews)

"This is a great wrench to make the job of changing a prop a real breeze. I would recommeng this to anyone who has to change a prop."...(read full reviews)

"I bought this lock for my Tempest Plus prop about 1 year ago. I leave it on the boat at all times. This lock does not hinder the performance of my boat in any way. After a year of use it still looks"...(read full reviews)

"I have a small boat, the CraigCat, that uses a stick streering setup. This product is exactly what I've been using for years to keep the steering lubed and working properly. It takes only a small"...(read full reviews)

"Everyone knows that long shaft motors are a dime a dozen and that its the short shafts that are hard to find. This product will bring value back to the long shafts and allow short transom boaters to"...(read full reviews)

"I took off about 3 inches of my skeg while running through a "shallow spot "and was looking for an easy fix when I ran across this Skeg Shield on the BPS sight. It has been several months since I put"...(read full reviews)

"my original tube broke, so this one replaced it perfectly. Very easy to install."...(read full reviews)

"i put it on my crestliner 1750 sportfish because my main motor( 150 yamaha) trolls to fast. i put a 4 horse yam. 4stroke and its great with the click in lowering plate. A+"...(read full reviews)

"Works great. I just used auto splicing clips to above cutting my trim wires, then added a length of wire lead with a ring terminal to hook up to the hot lead of the positive battery cable that went to"...(read full reviews)

"Both hands on the wheel equals better control. Perfect for a control freak like me. A must have for any boat that exceeds 50 MPH."...(read full reviews)

"I purchased this because I got fed up with crawling under the motor to install the other type of transom saver and having the motor constantly laying over to one side while trailering. With the"...(read full reviews)

"I have a Mercury Force 120 hp outboard and these are the best muffs for it! Others that are made out of plastic are junk, they slide off and don't push enough water in if you don't hold them on. These"...(read full reviews)

"I purchased this to put on my 2004 Yamaha 40hp motor. If you follow the instructions it will be an easy install. It works well."...(read full reviews)

"I have an older Merc 65 horse motor. I'm also 65 years old. This product has helped me avoid the next day sore back blues. I've now used my electric trolling motor more now since it's no big deal to"...(read full reviews)

"I have the CMC PL-65 Hydraulic on my Tracker Tournament V-18. I use it to jack a 150 Optimax. I have had this unit in service for about one year now. I have about 300 hours on it and so far it has"...(read full reviews)

"My buddies and I enjoy hunting and fishing a place that is pretty nasty to get into and out of with cypress knees, underwater stumps, beaver dams, etc. that have to be gone through and over to make it"...(read full reviews)

"Very dependable and versatile lock. I can use it for my Trolling Motor or my 9.9 Mariner. It's a must have for any transom mounted motors."...(read full reviews)

"I had these on my boat until I bought my jack plate. At that point they gave me way too much trim. They do exactly what they say they do...lots of extra trim. In some cases this can give you some more"...(read full reviews)